Ultraflex Rotech & Accura Steering Systems Guide

Speed, hull, horsepower, engine type displacement and size are major factors in boat performance and handling characteristics. The selection guide should be used as a general reference only.

One of the major factors in selecting a steering system is proper cable length. Due to specific routing in each boat, these approximate lengths will vary. Boating Solutions does recommend final selection should be made with the assistance of a qualified installation mechanic.

Ultraflex mechanical steering systems should not be used on boats equipped with engines that exceed the maximum horsepower rating of the boat.

Why the Ultraflex System vs other name brands?

The Ultraflex Rotech and Accura Steering systems use a Planetary Gear Helm with six contact point vs. one contact point by other named brands.

Benefits of a planetary design:
  • Increased longevity
  • Increased efficiency
  • Less feedback than conventional helms

Ultraflex® Helm with six contact points Teleflex® helm Morse® helm

Both the Teleflex® and Morse® helms rely on one contact point vs. six by the Ultraflex® steering helm.

Other features offered with a Ultraflex® Rotech or Accura Steering System:

Rotech I II Steering System Features:

New fast connection system
All stainless steel cable output ends
Lock-to-Lock steering wheel turns 3.8
Minimal feedback
Compact for mounting
Exceeds ABYC safety standards
For boats faster than 50 mph the twin cable system is recommended

Accura I II Steering System Features:


Patented zero torque feedback system
The non reversible steering helm eliminates propeller torque making steering easy and safe.
Ideal for larger outboards and surfacing propellers
All stainless steel cable output ends
Lock-to-Lock steering wheel turns 3.8
Compact for mounting
Exceeds ABYC safety standards
For boats faster than 50 mph the twin cable system is recommended

All Rotech and Accura Steering Systems come complete with everything needed to install your new steering system.

Parts Included:

  1. One single or dual cable helm
  2. Mounting Bezel 20° or 90°
  3. M66 steering cable (specify length when ordering)
  4. All hardware required for mounting

Use application charts below for matching and measuring the right system for your application.

Application
Engine Power
Steering System

Outboards

Up to 50 mph or 40 KW (55cv)

 

Rotech I single cable system

Accura I no feedback single cable system

 
Over 50 mph

Rotech II dual cable system

 

Inboards

Up to 35' length

Rotech I single cable system

Accura I no feedback single cable system

or

Rotech II dual cable system

 

Sterndrives
Up to 35' length

Rotech I single cable system

Accura I no feedback single cable system

or

Rotech II dual cable system

 
Rotech I System
Rotech II System
Accura I No Feedback

 

 

 

 
 

 

 

 
How to measure for new steering cable installation
Add A + B + C and subtract 4" (100mm) for each 90 degree bend in the cable. For installation through the engine tilt tube, add 12" (305 mm) to the measure calculated above.

 

Tilt Tube Mounting - Fig. 1 Transom Support or Splashwell Mounting Fig. 2 & 3

Figure 1.

Figure 2.

Figure 3.

Example: A (20") + B (100") + C (26") = 146" - 8" for two 90 degree bends = 138" + 12" for a thru-tube installation = 150" (12' 5") rounded off to 13 ft. Example: A (20") + B (100") +C (26") = 146" - 8" for two 90 degree bends = 138" (11' 5") rounded off to 12 ft.

 

When Measuring for a Replacement Cable Use the Guide Below