Boating Solutions Rack AndPinionSteering System Selection Guide

UflexRACKTECH™
RACK AND PINION STEERING SYSTEM

ACCUTECH™
NON-REVERSIBLE RACK
AND PINION STEERING SYSTEM

Steering Systems Guide

 

Speed, hull, horsepower, engine type displacement and size are major factors in boat performance and handling characteristics. The selection guide should be used as a general reference only.

One of the major factors in selecting a steering system is proper cable length. Due to specific routing in each boat, these approximate lengths will vary. Boating Solutions does recommend final selection should be made with the assistance of a qualified installation mechanic.

Ultraflex mechanical steering systems should not be used on boats equipped with engines that exceed the maximum horsepower rating of the boat.

 

How to measure for new steering cable installation
Add A + B + C and subtract 4" (100mm) for each 90 degree bend in the cable. For installation through the engine tilt tube, add 12" (305 mm) to the measure calculated above.

 

Tilt Tube Mounting - Fig. 1 Transom Support or Splashwell Mounting Fig. 2 & 3

Figure 1.

Figure 2.

Figure 3.

Example: A (20") + B (100") + C (26") = 146" - 8" for two 90 degree bends = 138" + 12" for a thru-tube installation = 150" (12' 5") rounded off to 13 ft. Example: A (20") + B (100") +C (26") = 146" - 8" for two 90 degree bends = 138" (11' 5") rounded off to 12 ft.

 

When Measuring for a Replacement Cable Use the Guide Below


 

Locate the correct Rack Steering System or part in the below table. After you have located the correct System or part you can click on the link which will take you to pricing and purchase options for that specific product.

 

RACKTECH RACK AND PINION SYSTEM
ACCUTECH NO FEEDBACK SYSTEM