A90X34 Uflex Twin Engine Tie Bar

Price: $465.95
  • SKUA90X34
- +

A90 Uflex Twin Engine Dual Cylinder Tie Bar

Heavy duty twin engine/twin cylinder tie bar kit for use with UC128 and UC128P "Port" version outboard cylinders. Suitable for use with Protech and SilverSteer cylinders, these 304 electropolished and passivated stainless steel tie bars are simple to install and allow for independent trimming of engines with minimal effect on engine alignment.

A90 Series Uflex Twin Engine Dual Cylinder Tie Bar

90 Twin Outboard Engine Setup Suitable for applications with dual UC128-OBF (or UC128-SVS) front mount
cylinder Note: in applications with single cylinder use A94 tie bar  Allows to tilt the engines independently
 Electropolished/passivated stainless steel components and ball joints  Applicable to engine centers variable from 26” (660 mm) to 36” (914,4 mm). 


Attention: As the tiller arm position varies from engine to engine and the distance between two engines is not predictable, unexpected interferences may occur while tilting. A duly check of the tie bar installation is then strongly recommended. Should you need additional information, please do not hesitate to refer to our Technical Service.

WARNING: In the applications with dual UC128-OBF (or UC128-SVS) cylinder it is necessary to order a standard UC128-OBF (or UC128-SVS) cylinder (link arm attached to the starboard side of the cylinder) and a UC128P-OBF (or UC128P-SVS) port cylinder (link arm attached to the port side of the cylinder).